Air Breeze 27' Air Guyed Tower Kit 1-TWA-10-01

The Air Breeze 27' Air Guyed Tower kits are Professional Engineer Certified (PE Certified). Each 1-TWA-10-01 tower kit comes with all hardware necessary to install a tower, except guy supports, pipe and cement. All parts bolt or clamp together and no welding is required. Purchase 1-7/8" steel tubing from chain link fence supplier. Roof mounts include vibration isolators, wall brace clamps and a safety leash, but do not include pole or lag screws.

In general, the taller the tower, the greater the wind speed and ultimately power production. However, towers are expensive and can easily exceed the cost of the turbine.

Safety must be the primary concern when selecting the mounting location. Install Air Breeze so there is no possibility of accidental contact with rotating blades even if it requires installing the wind turbine in a less than ideal location. Safety has precedence over efficiency.

Tower Kit Includes:

1 Tower Base

1 Wire set

2 Tower Base Staples

2 3/8" x 1 ½" Bolts

2 3/8" Locknuts

4 Cable Thimbles

8 Cable Clamps

Items NOT included in this Kit:

Anchors (The type of anchors used will depend on the soil conditions at your tower site. This is explained further in the "Anchors" section of the manual below.)

Ground Rod and Clamp

Lightning Arrestor

Junction Box and Adapter

Flex Conduit and Fitting

Electrical Wire

Wire Connectors (preferably copper split bolts)

Pipe Insulation (to prevent wire "rattle" inside pole)

Electrical tape

Tubing for the tower (this is explained in Step 2 on page 6 of manual)