Air Breeze 45' Air Guyed Tower Kit 1-TWA-10-02

The Air Breeze 45' Air Guyed Tower kits are Professional Engineer Certified (PE Certified). Each 1-TWA-10-02 tower kit comes with all hardware necessary to install a tower, except guy supports, pipe and cement. All parts bolt or clamp together and no welding is required. Purchase 1-7/8" steel tubing from chain link fence supplier. Roof mounts include vibration isolators, wall brace clamps and a safety leash, but do not include pole or lag screws.

Safety must be the primary concern when selecting the mounting location. Install Air Breeze so there is no possibility of accidental contact with rotating blades even if it requires installing the wind turbine in a less than ideal location. Safety has precedence over efficiency.

The Tower kit includes tower clamp/guy wire assemblies and all necessary hardware and fasteners to erect a 45' tilt-up tower using pipe or tubing with an outside diameter of 1.875"

Tower Setup Kit Parts List:

1 Gin Pole Cap

1 100' Rope

3 Snap Links – Work Load Rated to 400#

1 8-foot Cable

1 3/8" x 1 ½" Bolt

1 3/8" Lock-nut

Items Not Included In This Kit:

Anchors (The type of anchors used will depend on the ground makeup at your tower site. This is explained further in the "Anchors" section of the manual below.)

Tubing for Tower and Gin Pole

Ground Rod and Clamp

Lightning Arrestor

Junction Box and Adapter

Flex Conduit and Fitting

Electrical Wire

Wire Connectors (preferably copper split bolts)

Pipe Insulation (to prevent wire "rattle" inside pole)

Electrical tape